Behavior when merge layers with different opacity
Posted: Fri Mar 20, 2020 11:04 am
Thanks for the development and improvement of PaintstormStudio.
I think it is a low priority because there are workarounds, but I would be grateful if you could consider it.
The opacity of the upper layer is 100%.
The opacity of the lower layer is 10%.
Merge two layers.
This will merge into a layer with 10% opacity.
The opacity was different for the upper and lower layers, but the opacity is the same.
To avoid this, add another layer below the two layers.
Merge into a third 100% opacity layer to maintain the different opacity appearance.
In the case of Kirita, and painter CLIP STUDIO PAINT,
Just merge the two 100% and 10% layers.
It took time to understand this specification of PaintstormStudio.
I think it is a low priority because there are workarounds, but I would be grateful if you could consider it.
The opacity of the upper layer is 100%.
- The opacity of the upper layer is 100%
- Screen-2020-02-12_18-40-39.jpg (128.25KiB)Viewed 4760 times
- The opacity of the lower layer is 10%
- Screen-2020-02-12_18-40-58.jpg (127.89KiB)Viewed 4760 times
This will merge into a layer with 10% opacity.
- This will merge into a layer with 10% opacity
- Screen-2020-02-12_18-41-09.jpg (121.5KiB)Viewed 4760 times
To avoid this, add another layer below the two layers.
Merge into a third 100% opacity layer to maintain the different opacity appearance.
In the case of Kirita, and painter CLIP STUDIO PAINT,
Just merge the two 100% and 10% layers.
- case of Kirita
- 200213Kirita.jpg (84.38KiB)Viewed 4760 times
