Interface setup not saving/loading properly

Post Reply
JBernal
Posts:27
Joined:Sun Apr 02, 2017 5:00 pm
Interface setup not saving/loading properly

Post by JBernal » Wed Jan 24, 2018 3:54 pm

The interface is either not saving or not loading properly. The menus I normally have on the far right somehow end up in the middle when I start up Paintstorm. Even if I save the layout again in the proper places, it still loads them incorrectly once I restart paintstorm. See screenshots.
OSX High Sierra 10.13.3
Paintstorm 2.10-121117
Attachments
how_it_should_be.png
how_it_should_be.png (751.51KiB)Viewed 2360 times
how_it_is.png
how_it_is.png (761.79KiB)Viewed 2360 times
User avatar
support
Site Admin
Posts:1663
Joined:Thu May 07, 2015 1:33 pm

Re: Interface setup not saving/loading properly

Post by support » Thu Jan 25, 2018 9:49 am

Do you have a single monitor? This could happen if Paintstorm window has been folded and unfolded, for example - setup on 2560x1440 and folded to 1920x1080 then back.
JBernal
Posts:27
Joined:Sun Apr 02, 2017 5:00 pm

Re: Interface setup not saving/loading properly

Post by JBernal » Sat Jan 27, 2018 1:57 am

I use two monitors.

Also tested it in the latest release (2.20-150118) and it does the same thing.
User avatar
support
Site Admin
Posts:1663
Joined:Thu May 07, 2015 1:33 pm

Re: Interface setup not saving/loading properly

Post by support » Sat Feb 17, 2018 9:33 am

You can try next trick: switch to another workspace (f5,f6,f7,f8,f9 hotkeys) before the exit and back to your next time.
JBernal
Posts:27
Joined:Sun Apr 02, 2017 5:00 pm

Re: Interface setup not saving/loading properly

Post by JBernal » Thu May 03, 2018 5:07 pm

support wrote:You can try next trick: switch to another workspace (f5,f6,f7,f8,f9 hotkeys) before the exit and back to your next time.
I tried that, it doesn't work.
Post Reply